Configuring System Information 169
•
Accounting Mode
— Use the menu to select whether the RADIUS accounting mode is enabled or
disabled on the current server.
•
RADIUS Attribute 4 (NAS-IP Address)
— To set the network access server (NAS) IP address for the
RADIUS server, select the option and enter the IP address of the NAS in the available field. The
address should be unique to the NAS within the scope of the RADIUS server. The NAS IP address is
only used in Access-Request packets.
Configuring Global RADIUS Settings Using CLI Commands
For information about the CLI commands that perform this function, see the
RADIUS Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use.
RADIUS Server Configuration
From the RADIUS Server Configuration page, you can add a new RADIUS server, configure settings for
a new or existing RADIUS server, and view RADIUS server status information. The RADIUS client on
the switch supports up to 32 named authentication and accounting servers.
To access the RADIUS Server Configuration page, click System
→
Management Security
→
RADIUS
Server Configuration in the tree view.
Table 6-31. RADIUS Global Commands
CLI Command Description
radius-server attribute Sets the network access server (NAS) IP address for the RADIUS
server.
radius-server retransmit Specifies the number of times the software searches the list of
RADIUS server hosts.
radius-server timeout Sets the interval for which a switch waits for a server host to reply.
show radius-servers Displays the RADIUS server settings.
To Next Page
Loading...
