Configuring Routing 593
2.
Specify the loopback to be affected.
3.
Specify the secondary address to be removed.
4.
Click
Delete Selected Secondary
.
The secondary address is deleted, and the device is updated.
Configuring a Loopback using CLI Commands
For information about the CLI commands that perform this function, see the following chapters in the
CLI Reference Guide:
• Loopback Interface Commands
• IP Addressing Commands
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
Loopbacks Summary
Use the Loopbacks Summary
page to display a summary of configured loopbacks.
To display the page, click Routing
→
Loopbacks
→
Summary in the tree view.
Table 9-43. Loopback Commands
CLI Command Description
interface loopback Enters the Interface Loopback configuration mode.
ip address Configures an IP address on an interface.
ipv6 address Configures an IPv6 address on an interface (including tunnel and
loopback interfaces).
To Next Page
Loading...
