Dell PowerConnect 8024 - Page 592

592 Configuring Routing
Figure 9-57. Loopbacks Configuration - IPv6 Entry
5. Choose IPv6 from the drop-down box in the Protocol field.
6. Add the IPv6 Address .
7. Enter desired values in the remaining fields.
8. Click Submit .
The new loopback is saved, and the device is updated.
Configuring an Existing Loopback
1. Open the Loopback Configuration page.
2. Specify the loopback to configure in the Loopback drop-down menu.
3. Change field values as desired in the remaining fields.
4. Click Apply Changes .
The new configuration is saved, and the device is updated.
Removing a Loopback
1. Open the Loopback Configuration page.
2. Specify the loopback to remove in the Loopback drop-down menu.
3. Click Delete Loopback .
The loopback is deleted, and the device is updated.
Removing a Secondary Address
1. Open the Loopback Configuration page.