Dell PowerConnect 8024 User Guide

Configuring Routing 535
The following table summarizes the equivalent CLI commands for this feature.
Route Redistribution Summary
Use the OSPF Route Redistribution Summary page to display OSPF Route Redistribution
configurations.
To display the page, click Routing
→ OSPF → Route Redistribution Summary in the tree view.
Figure 9-20. OSPF Route Redistribution Summary
The OSPF Route Redistribution Summary page contains the following fields:
• Source — The Source Route to be redistributed by OSPF.
•
Redistribute — Specify whether to allow the routes learned through this protocol to be redistributed.
•
Metric — The Metric of redistributed routes for the given Source Route. Displays 0 when not
configured.
•
Metric Type — The OSPF metric type of redistributed routes.
•
Tag — The tag field in routes redistributed. This field displays the tag value if the source was
preconfigured, otherwise 0 is displayed.
•
Subnets — Specify whether the subnetted routes should be redistributed ( Enable ) or not ( Disable ).
Table 9-17. OSPF Route Redistribution Configuration Commands
CLI Command Description
redistribute Configures OSPF protocol to allow redistribution of routes from the
specified source protocol/routers.
distribute-list out Specifies the access list to filter routes received from the source
protocol.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries