Dell PowerConnect 8024 User Guide

Configuring System Information 199
• Blocked Status — Indicates whether authentication attempts to the captive portal are currently
blocked.
Use the Block and Unblock buttons to control the blocked status. If the CP is blocked, users cannot
gain access to the network through the CP. Use this function to temporarily protect the network during
unexpected events, such as denial of service attacks.
•
Authenticated Users — Shows the number of users that successfully authenticated to this captive
portal and are currently using the portal.
The following buttons are available on the CP Activation and Activity page:
• Block —Click Block to prevent users from gaining access to the network through the selected captive
portal.
•
Unblock —If the Blocked Status of the selected captive portal is Blocked, click Unblock to allow access
to the network through the captive portal.
Interface Activation Status
The Interface Activation Status page shows information for every interface assigned to a captive portal
instance.
To view interface activation status information, click System
→ Captive Portal → Interface Activation
Status.
Figure 6-80. Interface Activation Status
The Interface Activation Status page contains the following fields:

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries