Dell PowerConnect 8024 User Guide

Configuring System Information 255
– macAddress — Indicates that the value is in the form of Layer 2 MAC address.
–
other — Indicates that the value is in the form of a platform specific ASCII string containing info
that identifies the device. For example: ASCII string contains serialNumber appended/prepended
with system name.
Configuring ISDP Using CLI Commands
For information about the CLI commands that perform this function, see the CDP Interoperability
Commands
chapter in the CLI Reference Guide . The following table summarizes the equivalent CLI
commands you use to configure ISDP.
Cache Table
From the ISDP Cache Table page, you can view information about other devices the switch has
discovered through the ISDP.
To access the ISDP Cache Table page, click System
→ ISDP → Cache Table in the navigation tree.
Table 6-62. ISDP Commands
CLI Command Description
isdp advertise-v2 Enables the sending of ISDP version 2 packets from the device.
isdp enable Enables ISDP on the switch.
isdp holdtime Configures the hold time for ISDP packets that the switch transmits.
isdp timer Sets period of time between sending new ISDP packets.
show isdp Displays global ISDP settings.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries