612 Configuring IPv6
The following table summarizes the equivalent CLI commands for this feature.
DHCPv6 Pool Configuration
DHCP for IPv6 clients are connected to a server which is configured to use parameters from a pool that
you set up. The pool is identified with a pool name, and contains IPv6 addresses and domain names of
DNS servers.
Use the Pool Configuration
page to create a pool and/or configure pool parameters.
To display the page, click IPv6
→
DHCPv6
→
Pool Configuration in the tree view.
Figure 10-7. Pool Configuration - Create
The Pool Configuration page contains the following fields:
•
Pool Name
— Drop-down menu that lists all the pool names configured. When
Create
is selected,
fields on the page are cleared of data, in preparation for new pool information.
•
Pool Name
— Displays the pool selected from the previous field, or provides entry of a unique name
for a DHCPv6 pool when Create is selected. A maximum of 31 alphanumeric characters can be
entered.
Table 10-6. DHCPv6 Global Commands
CLI Command Description
service dhcpv6 Enables DHCPv6 configuration on the router.
show ipv6 dhcp Displays the DHCPv6 server name and status.
To Next Page
Loading...
