Dell PowerConnect 8024 User Guide

Configuring IPv6 611
Figure 10-6. DHCPv6 Global Configuration
The DHCPv6 Global Configuration page contains the following fields:
• DHCPv6 Admin Mode — Specifies DHCPv6 operation on the switch. Possible values are Enable and
Disable; the default value is Disable.
•
Relay Option — Specifies Relay Agent Information Option value. The values allowed are between 32
to 65535, and represent the value exchanged between the relay agent and the server. Each value has a
different meaning, of which 1 to 39 are standardized. The default value, 32, means
OPTION_INFORMATION_REFRESH_TIME.
•
Remote-id Sub-option — Lets you specify a number to represent the Relay Agent Information Option
Remote-ID Sub-option type. The values allowed are between 1 and 65535. The default value is 1.
Configuring DHCPv6 Global Parameters
1. Open the DHCPv6 Global Configuration page.
2. Modify the fields as needed.
3. Click Apply Changes .
The DHCPv6 parameter modifications are saved, and the device is updated.
Configuring DHCPv6 Global Parameters Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• DHCPv6 Commands

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries