228 Configuring System Information
To display the File System page, click System
→
File Management
→
Active Images in the tree view.
Figure 6-107. Active Images
The Active Images page contains the following fields:
•
Unit —
The unit on which the active image is running.
•
Active Image —
The name of the current active image.
•
Version —
The version of the current active image.
•
After Reset —
From the menu, select the image that should be active after the next reset.
•
Version —
Displays the version of the image after reset.
Setting the Boot Image Using CLI Commands
For information about the CLI command that performs this function, see the
Configuration and Image
File Commands
chapter in the
CLI Reference Guide
. The following table shows the equivalent CLI
command you use to configure the boot image.
File Download
Use the File Download page to download image (binary) files, SSH and SSL certificates, and
configuration (ASCII), files from the server to the device.
To display the File Download page, click System
→
File Management
→
File Download in the tree view.
Table 6-49. Set Boot Image Command
CLI Command Description
boot system Specifies the system image that the switch loads at startup.
To Next Page
Loading...
