Dell PowerConnect 8024 User Guide

766 Configuring IP Multicast
Figure 12-40. Add Static RP
3. Enter the IP address of the RP for the group range.
4. Enter the group address of the RP.
5. Enter the group mask of the RP.
6. Check the Override option to configure the static RP to override the dynamic (candidate) RPs learned
for same group ranges.
7. Click Apply Changes .
The new Static RP is added, and the device is updated.
Configuring the Candidate RP Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• PIM Commands
The following table summarizes the equivalent CLI commands for this feature.
SSM Range Configuration
Use this page to display or remove the the Source Specific Multicast (SSM) group IP address and group
mask for the PIM router.
To display the page, click IPv4 Multicast
→ PIM → SSM Range Configuration or IPv6 Multicast → PIM
→ SSM Candidate Configuration.
Table 12-37. PIM Candidate RP Configuration Commands
CLI Command Description
ipv6 pimsm rp-address Statically configures the RP address for one or more multicast groups.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries