172 Configuring System Information
Figure 6-57. RADIUS Server Status
3.
To remove a named server, select the check box in the
Remove
column.
4.
Click
Apply Changes
.
The RADIUS server is removed from the list.
Configuring RADIUS Server Settings Using CLI Commands
For information about the CLI commands that perform this function, see the
RADIUS Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use.
RADIUS Accounting Server Configuration
From the RADIUS Accounting Server Configuration page, you can add a new RADIUS accounting
server, configure settings for a new or existing RADIUS accounting server, and view RADIUS accounting
server status information. The RADIUS client on the switch supports up to 32 named authentication
and accounting servers.
To access the RADIUS Server Configuration page, click System
→
Management Security
→
RADIUS
Accounting Server Configuration
in the tree view.
Table 6-32. RADIUS Server Commands
CLI Command Description
auth-port Sets the port number for authentication requests of the designated
radius server.
key Sets the authentication and encryption key for all RADIUS
communications between the switch and the RADIUS daemon.
msgauth Enables the message authenticator attribute to be used for the
RADIUS Authenticating server being configured.
name Assigns a name to a RADIUS server.
primary Specifies that a configured server should be the primary server in the
group of authentication servers which have the same server name.
radius-server host Specifies a RADIUS server host and enter RADIUS Configuration
mode.
show radius-servers Displays the RADIUS server settings.
To Next Page
Loading...
Need help?
General
