Dell PowerConnect 8024 User Guide

448 Configuring Switching Information
Viewing DHCP Relay Statistics With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
the
CLI Reference Guide :
• L2 DHCP Relay Agent Commands
The following table summarizes the equivalent CLI commands for this feature.
DHCP Relay VLAN Configuration
You can enable L2 DHCP relay on a particular VLAN. The VLAN is identified by a service VLAN ID (S-
VID), which a service provider uses to identify a customer’s traffic while traversing the provider network
to multiple remote sites. The switch uses the VLAN membership of the switch port client (the customer
VLAN ID, or C-VID) to perform a lookup a corresponding S-VID.
If the S-VID is enabled for DHCP Relay, then the packet can be forwarded. If the C-VID does not
correspond to an S-VID that is enabled for DHCP Relay, then the switch will not relay the DHCP request
packet.
To access this page, click Switching
→ DHCP Relay → VLAN Configuration in the tree view.
Table 7-74. DHCP Relay Statistics Configuration Command
CLI Command Description
show dhcp l2relay stats Displays statistics for L2 DHCP relay.
clear dhcp l2relay statistics Clears all dhcp L2 relay statistics.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries