692 Configuring Quality of Service
Figure 11-18. Interface Configuration
The Interface Configuration page contains the following fields:
•
Interface
— Selects the interface to be affected by the
Interface Shaping Rate
. Select
Unit/Port
, or
LAG
to be affected from the drop-down menu. Select
Global
to specify all interfaces.
•
Interface Shaping Rate
— Sets the cap on how much traffic can leave a port. The specified value
represents the maximum negotiated bandwidth in kilobit per second (Kbps). The range is 0 - Infinity
or 64 to 4294967295 kbps.
•
Restore to Defaults
— Restores the default interface shaping rate to the selected interfaces when
checked.
Defining Interface Configuration
1.
Open the
Interface Configuration
page.
2.
Select the unit and port or LAG
to be affected, or select Global to apply the settings to all interfaces.
3.
Enter an
Interface Shaping Rate
to apply to these ports.
4.
Click
Apply Changes
.
The new
Interface Shaping Rate
is applied to the selected interface(s) and the device is updated.
Restoring Default Shaping Rate
1.
Open the
Interface Configuration
page.
2.
Click the
Restore to Defaults
check box.
3.
Click
Apply Changes
.
All ports are restored to the default shaping rate, and the device is updated.
To Next Page
Loading...
