698 Configuring Quality of Service
Figure 11-22. Auto VoIP Interface Configuration
The Auto VoIP Interface Configuration page contains the following fields:
•
Interface
— Lists the interfaces, Unit and Port or LAG, on which Auto VoIP can be configured.
•
Auto VoIP Mode
— Use the mode setting to either Enable or Disable the Auto VoIP mode on the
selected interface. The default is Disable.
•
Traffic Class
—Displays the traffic class used for VoIP traffic.
Viewing the Auto VoIP Summary Table
1.
Open the
Auto VoIP Interface Configuration
page.
2.
Click
Show All
.
The
Auto VoIP Summary
page opens.
Figure 11-23. Auto VoIP Summary
Configuring Auto VoIP Interfaces Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands
To Next Page
Loading...
