Dell PowerConnect 8024 - Page 121

Configuring System Information 121
The SNTP Servers Table page displays.
Figure 6-15. SNTP Servers Table
Modifying an SNTP Server
1. Open the SNTP Servers page.
2. Click Show All.
The SNTP Servers Table opens.
3. Click Edit next to the SNTP Server entry you wish to modify.
4. Modify the relevant fields.
5. Click Apply Changes .
The SNTP server information is updated.
Removing the SNTP Server
1. Open the SNTP Servers page.
2. Click Show All.
The SNTP Servers Table opens.
3. Select an SNTP Server entry.
4. Check the Remove check box.
5. Click Apply Changes .
The entry is removed, and the device is updated.
Defining SNTP Servers Using CLI Commands
For information about the CLI commands that perform this function, see the Clock Commands chapter
in the
CLI Reference Guide . The following table summarizes the equivalent CLI commands you use to
define SNTP servers.