Configuring System Information 129
Sending Logs to a Server
1.
Open the
Remote Log Server Settings
page.
2.
Define the
UDP Port
,
Facility
, and
Description
fields.
3.
Select the log type and log severity by using the
Log Parameters
check boxes.
NOTE: When you select a severity level, all higher severity levels are automatically selected.
4.
Click
Apply Changes
.
The log settings are saved, and the device is updated.
Adding a New Server
1.
Open the
Remote Log Server Settings
page.
2.
Click
Add
to display the
Add Remote Log Server
page.
NOTE: Before adding a new server, determine the IP address of the remote log server.
Figure 6-20. Add Remote Log Server Settings
3.
Complete the fields in the dialog and click
Apply Changes
.
The
Remote Log Server Settings
page displays the server in the
Log Server
list only after you go back
to the
Remote Log Server Settings
page.
Viewing/Removing a Log Server
1.
Open the
Remote Log Server Settings
page.