Configuring System Information 139
•
IPv6 Gateway
— Enter the IPv6 gateway address (do not include a prefix). Use an IPv6 global or link-
local address format.
•
Add IPv6 Address
— To add an IPv6 address, select Add so you can specify an address in the New IPv6
Address field.
•
New IPv6 Address
— If
Add
is selected from the Add IPv6 Address field, enter an IPv6 prefix/length in
this field.
•
EUI Flag
— Select True if the last 64 bits are to be derived from the MAC address. For example, you
can enter 2001::/64 and have the EUI Flag (True) use the 64-bit address calculated from the MAC
address.
Displaying IPv6 Address Management Information
1.
Open the
IPv6 Address Management
page.
2.
Click
Show All
to display the
IPv6 Management Summary
page.
Figure 6-32. IPv6 Management Summary
3.
To remove an IPv6 Address, select the Remove option associated with the address, and click
Apply
Changes
.
Viewing IPv6 Management Information Using CLI Commands
For information about the CLI commands that perform this function, see the
IP Addressing Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use.
Table 6-21. Ipv6 Management Information Commands
CLI Command Description
ipv6 address Use to display the entries in the ARP table.
ipv6 enable Enables IPv6 on the management interface.
ipv6 gateway Configures an IPv6 gateway for the management interface.
To Next Page
Loading...
