Dell PowerConnect 8024 User Guide

174 Configuring System Information
2. Click Add .
The
Add RADIUS Accounting Server page displays.
Figure 6-59. Add RADIUS Accounting Server
3. Enter an IP address and name for the RADIUS accounting server to add.
4. Click Apply Changes .
The new RADIUS server is added, and the device is updated.
Viewing RADIUS Accounting Server Status and Removing a Accounting Named Server
1. Open the RADIUS Accounting Server Configuration page.
2. Click Show All .
The
RADIUS Named Accounting Server Status page displays.
Figure 6-60. RADIUS Accounting Server Status
3. To remove a named accounting server, select the check box in the Remove column.
4. Click Apply Changes .
The RADIUS accounting server is removed from the list.
Configuring RADIUS Accounting Server Settings Using CLI Commands
For information about the CLI commands that perform this function, see the RADIUS Commands
chapter in the CLI Reference Guide . The following table summarizes the equivalent CLI commands you
use.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries