204 Configuring System Information
Figure 6-85. CP - Client Status
The CP - Client Status page contains the following fields:
•
Configuration Name
— The drop-down menu lists each CP configured on the switch. To view
information about the clients connected to the CP configuration, select the CP configuration name
from the list.
•
MAC Address
— Identifies the MAC address of the client.
•
IP Address
— Identifies the IP address of the client.
•
Interface
— Identifies the interface the client used to access the network.
•
Protocol
— Shows the current connection protocol, which is either HTTP or HTTPS.
•
Verification
— Shows the current account type, which is Guest, Local, or RADIUS.
Configuring Captive Portal Settings Using CLI Commands
For information about the CLI commands that perform this function, see the Captive Portal
Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use to configure Captive Portal.
Table 6-40. Captive Portal Configuration Commands
CLI Command Description
authentication timeout Configures the authentication timeout.
captive-portal Enables the captive portal configuration mode.
http port Configures an additional HTTP port for captive portal to monitor.
https port Configures an additional HTTPS port for captive portal to monitor.
show captive-portal Displays the status of captive portal.
show captive-portal status Reports the status of all captive portal instances in the system.
block Blocks all traffic for a captive portal configuration.
To Next Page
Loading...
