Dell PowerConnect 8024 - Page 233

Configuring System Information 233
To display the Copy Files page, click System → File Management → Copy Files in the tree view.
Figure 6-110. Copy Files
The Copy Files page contains the following fields:
• Copy Master Firmware — Specifies that a software image file should be copied.
•
Destination — The destination unit(s) (within the stack) to which the file is copied. Select from the
menu one of the following values:
–
All — All units in the stack.
–
Unit — Specified unit within the stack, unit 1 for example.
•
Copy Configuration — Specifies that a configuration file should be copied.
•
Source — The configuration source file from which the file is copied. Select from the menu one of the
following possible values:
–
Running Config — Uploads the running configuration file.
–
Startup Config — Uploads the startup configuration file.
–
Backup Config — Uploads the backup configuration file.
•
Destination — The destination configuration file to which the file is copied. Select from the menu
one of the following:
–
Startup Config — The startup configuration file.
–
Backup Config — The backup configuration file.
•
Restore Configuration Factory Default — Select the radio button and click Apply Changes to restore
all configuration structures to the defaults.