Dell PowerConnect 8024 - Page 264

264 Configuring System Information
Figure 6-131. iSCSI Sessions
The iSCSI Sessions page contain the following fields:
Target N a me — Identifies the name of the iSCSI target.
Initiator Name — Identifies the name of the iSCSI initiator.
iSCSI Identifiers— Identifies the Initiator Defined Session Identifier (ISID) value.
Configuring iSCSI Optimization Using CLI Commands
For information about the CLI commands that perform this function, see the iSCSI Commands chapter
in the
CLI Reference Guide :
The following table summarizes the equivalent CLI commands you use to configure iSCSI.
Table 6-66. iSCSI Optimization Interface Commands
CLI Command Description
iscsi enable Globally enables iSCSI awareness.
iscsi target port Configures an iSCSI target port and, optionally, address and name.
iscsi cos Sets the quality of service profile that will be applied to iSCSI flows.
iscsi aging time Sets aging time for iSCSI sessions.
cut-through Enables Alternate Store and Forward (ASF) mode.
show iscsi Displays iSCSI settings.
show iscsi sessions Displays iSCSI session information.