298 Configuring Switching Information
Enabling Ingress Backpressure
1.
Open the
Ports Global Parameters
page.
2.
Select Enable from the drop-down menu in the
Flow Control
field.
3.
Click
Apply Changes
.
4.
Ingress backpressure is now enabled.
Configuring Flow Control Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Ethernet Configuration Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 7-11. Port Configuration Commands
CLI Command Description
flowcontrol Enables flow control.
show interfaces configuration Displays the configuration for all configured interfaces.
To Next Page
Loading...
