Dell PowerConnect 8024 - Page 321

Configuring Switching Information 321
The parameters are copied to the selected ports or LAGs in the GARP Timers Table, and the device is
updated.
Displaying Parameters in the GARP Timers Table
1. Open the GARP Timers page.
2. Click Show All .
The
GARP Timers Table displays.
Figure 7-37. GARP Timers Table
3. Use the Unit drop-down menu to view the GARP Timers Table for other units in the stack, if they
exist.
Copying GARP Timers Settings
1. Open the GARP Timers page.
2. Click Show All .
The
GARP Timers Table displays.
3. Specify the Unit and Port you are copying from in Copy Parameters From .
4. Click Copy To for each Interface to receive these parameters.
5. Click Apply Changes .
The GARP Timers settings are copied, and the device is updated.
Modifying GARP Timers Settings for Multiple Ports
1. Open the GARP Timers page.
2. Click Show All .