Dell PowerConnect 8024 - Page 338

338 Configuring Switching Information
4. Specify Interface Priority and Path Cost .
5. Click Apply Changes .
The interface settings are saved, and the device is updated.
Displaying the MSTP Interface Settings Table
1. Open the MSTP Settings page.
2. Click Show All .
The
MSTP Interface Table displays.
Figure 7-48. MSTP Interface Table
3. Use the Unit drop-down menu to view the MSTP Interface Table for other units in the stack, if they
exist.
4. To modify the port priority or path cost for one or more interfaces, check Edit for the desired
interfaces.
5. Make the needed changes to the values in the Port Priority or Path Cost columns.
6. Click Apply Changes.
The fields are modified for the selected Interfaces, and the device is updated.
Defining MSTP Interfaces Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Spanning Tree Commands
Configuring MST Port Settings Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :