Dell PowerConnect 8024 - Page 391

Configuring Switching Information 391
• Auto Learn — Enable or Disable the ability of the switch to automatically learn about dynamic MLD
ports.
• Host Timeout — Specifies time (in seconds) before an MLD snooping entry is aged out. The range is
from 2 to 3600 seconds. The default time is 260 seconds.
• Multicast Router Timeout — Specifies time (in seconds) before aging out a Multicast router entry.
The range is 1 to 3600 seconds. The default value is 300 seconds.
• Leave Timeout — Specifies the amount of time (in seconds) after a port leave message is received
before the entry is aged out. Enter value for the timeout period, or click Immediate Leave to specify an
immediate timeout. The range is from 1 to 3599 seconds. The default timeout is 10 seconds.
Displaying the MLD Snooping Table
1. Open the MLD Snooping General page.
2. Click Show All .
The
MLD Snooping Table displays.
Figure 7-87. MLD Snooping Table
Copying MLD Snooping Settings to Multiple Ports, LAGs, or VLANs
1. Open the General MLD snooping page.
2. Click Show All .
The
MLD Snooping Table displays.
3. Click Copy Parameters From .
4. Select a Unit/Port, LAG, or VLAN to use as the source of the desired parameters.
5. Click Copy To for the Unit/Ports, LAGs, or VLANs that these parameters will be copied to.
6. Click Apply Changes .
The MLD Snooping settings are modified, and the device is updated.