408 Configuring Switching Information
To display the LLDP-MED Global Configuration page, click Switching
→
LLDP
→
LLDP-MED
→
LLDP-MED Global Configuration in the tree view.
Figure 7-99. LLDP-MED Global Configuration
The LLDP-MED Global Configuration page contains the following fields:
•
Fast Start Repeat Count
— Specifies the number of LLDP PDUs that will be transmitted when the
protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 4.
•
Device Class
— Specifies local device's MED Classification. There are four different kinds of devices,
three of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone
etc.]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router,
IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point, and so on.
Modifying the LLDP-MED Global Configuration
1.
Open the
LLDP Configuration
page.
2.
Enter a new value for the Fast Start Repeat Count.
3.
Click
Apply Changes
.
LLDP-MED parameters are saved to the switch.
Configuring LLDP-MED Global Settings with CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
To Next Page
Loading...
