Dell PowerConnect 8024 - Page 479

Viewing Statistics and Remote Monitoring 479
Displaying the Alarm Table
1. Open the RMON Alarms page.
2. Click Show All.
The left side of the RMON Alarms Table displays.
Figure 8-18. RMON Alarms Table
3. Click the right arrow at the bottom of the screen to view the right side of the table.
Removing One Alarm Table Entry
1. Open the RMON Alarms page.
2. Select an entry in the Alarm Entry drop-down menu.
3. Check the Remove check box and click Apply Changes .
The entry is removed, and the device is updated.
Removing Multiple Alarm Table Entries
1. Open the RMON Alarms page.
2. Click Show All.
The RMON Alarms Table displays.
3. Check Remove for each Alarm Entry to remove.
4. Click Apply Changes .
The entries are removed, and the device is updated.
Defining Switch Alarms Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• RMON Commands
The following table summarizes the equivalent CLI commands for this feature.