498 Configuring Routing
Modifying an IP Interface
1.
Open the
IP Interface Configuration
page.
2.
Change values as needed.
3.
Click
Apply Changes
.
Changes are saved, and the IP Interface is updated.
IP Interface Configuration CLI Commands
For information about the CLI commands that perform this function, see the following chapters in the
CLI Reference Guide:
• IP Addressing Commands
• IP Routing Commands
• ARP Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-5. IP Interface Configuration Commands
CLI Command Description
routing Enables IPv4 and IPv6 routing for an interface.
encapsulation Configures the link layer encapsulation type for the packet.
ip address Configures an IP address on an interface.
ip mtu Sets the IP Maximum Transmission Unit (MTU) on a routing
interface.
ip netdirbcast Enables the forwarding of network-directed broadcasts.
show ip interface Displays all pertinent information about the IP interface.
To Next Page
Loading...
