Dell PowerConnect 8024 - Page 554

554 Configuring Routing
destination netmask in the access list serves as a wildcard mask, indicating which bits in the route’s
destination mask are significant for the filtering operation.
•
Redistribute — Enables or disables the redistribution for the selected source protocol. This field has to
be enabled in order to be able to configure any of the route redistribution attributes.
Creating a Configured Source
1. Open the RIP Route Redistribution Configuration page.
2. Select an Available Source to configure.
3. Specify values for the remaining fields.
4. Click Apply Changes .
The specified Source is now configured, and the device is updated.
Modifying a Configured Source
1. Open the RIP Route Redistribution Configuration page.
2. Select the Configured Source to modify.
3. Change values on this screen as needed.
4. Click Apply Changes
Specified changes are saved, and the device is updated.
Configuring RIP Route Redistribution using CLI Command
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• Routing Information Protocol (RIP) Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-27. RIP Route Redistribution Commands
CLI Command Description
redistribute Configures OSPF protocol to allow redistribution of routes from the
specified source protocol/routers.
distribute-list out Specifies the access list to filter routes received from the source
protocol.