Dell PowerConnect 8024 User Guide

570 Configuring Routing
Figure 9-41. VLAN Routing Summary
The VLAN Routing Summary page displays the following fields:
• VLAN ID — The ID of the VLAN whose data is displayed in the current table row.
•
MAC Address — The MAC Address assigned to the VLAN Routing Interface.
•
IP Address — The configured IP address of the VLAN Routing Interface.
NOTE: If a VLAN is created and the IP address is not configured, the web page by default shows an IP address of
0.0.0.0. To configure the IP address, go to the Routing
→ IP → Interface Configuration page. See "IP Interface
Configuration" on page 496.
• Subnet Mask — The configured subnet mask of the VLAN Routing Interface. This is 0.0.0.0 when the
VLAN Routing Interface is first configured and must be entered on the
Routing → IP → Interface
Configuration
page.
Displaying the VLAN Routing Summary Using CLI Commands
For information about the CLI commands that perform this function, see the following chapters in the
CLI Reference Guide:
• IP Addressing Commands
• Virtual LAN Routing Commands
The following table summarizes the equivalent CLI commands for this feature.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries