Dell PowerConnect 8024 - Page 597

Configuring IPv6 597
Configuring IPv6 Parameters
1. Open the IPv6 Global Configuration page.
2. Enable or disable unicast routing from the drop-down menu.
3. Enable or disable IPv6 frames forwarding from the drop-down menu.
4. Click Apply Changes .
Settings are saved, and the device is updated.
Configuring IPv6 Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• IPv6 Routing Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 10-1. IPv6 Routing Global Commands
CLI Command Description
ipv6 forwarding Enables IPv6 forwarding on a router.
ipv6 icmp error-interval Limits the rate at which ICMP error messages are sent.
ipv6 unicast-routing Enables forwarding of IPv6 unicast datagrams.
show ipv6 brief Displays the IPv6 status of forwarding mode and IPv6 unicast routing
mode.