Dell PowerConnect 8024 User Guide

Configuring IPv6 623
Messages Received
This section specifies the aggregate of all interface level statistics for received messages:
• DHCPv6 Solicit Packets Received — Specifies the number of Solicits.
•
DHCPv6 Request Packets Received — Specifies the number of Requests.
•
DHCPv6 Confirm Packets Received — Specifies the number of Confirms.
•
DHCPv6 Renew Packets Received — Specifies the number of Renews.
•
DHCPv6 Rebind Packets Received — Specifies the number of Rebinds.
•
DHCPv6 Release Packets Received — Specifies the number of Releases.
•
DHCPv6 Decline Packets Received — Specifies the number of Declines.
•
DHCPv6 Inform Packets Received — Specifies the number of Informs.
•
DHCPv6 Relay-forward Packets Received — Specifies the number of Relay forwards.
•
DHCPv6 Relay-reply Packets Received — Specifies the number of Relay Replies.
•
DHCPv6 Malformed Packets Received — Specifies the number of Malformed Packets.
•
Received DHCPv6 Packets Discarded — Specifies the number of Packets Discarded.
•
Total DHCPv6 Packets Received — Specifies the total number of Packets Received.
Messages Sent
This section specifies the aggregate of all interface level statistics for messages sent:
• DHCPv6 Advertisement Packets Transmitted — Specifies the number of Advertisements.
•
DHCPv6 Reply Packets Transmitted — Specifies the number of Replies.
•
DHCPv6 Reconfig Packets Transmitted — Specifies the number of Reconfigurations.
•
DHCPv6 Relay-forward Packets Transmitted — Specifies the number of Relay forwards.
•
DHCPv6 Relay-reply Packets Transmitted — Specifies the number of Relay Replies.
•
Total DHCPv6 Packets Sent — Specifies the total number of Packets Transmitted.
•
Clear — Resets the interface packet counters.
Displaying DHCPv6 Statistics
1. Open the DHCPv6 Statistics page.
2. Select the interface to be displayed from the Interface drop-down menu.
DHCPv6 statistics display for the selected interface.
Displaying DHCPv6 Statistics Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries