Configuring IPv6 635
•
LSDB Type
— The Link Advertisement type for the address range and area.
•
Advertisement
— The Advertisement mode for the address range and area.
•
Delete
— Click this check box to delete the specified OSPFv3 area range.
Configuring OSPFv3 Area Range
1.
Open the
OSPFv3 Area Range Configuration
page.
2.
Modify the fields as needed.
3.
Click
Apply Changes
.
The OSPFv3 area range is saved, and the device is updated.
Configuring OSPFv3 Area Range Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• OSPFv3 Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 10-16. OSPFv3 Area Range Command
CLI Command Description
area range Creates an area range for a specified NSSA.
show ipv6 ospf range Displays information about the area ranges for the specified area
identifier.
To Next Page
Loading...
