Configuring IP Multicast 715
Figure 12-9. DVMRP Interface Configuration
The DVMRP Interface Configuration page contains the following fields:
•
Interface
— Select the interface for which data is to be configured. You must configure at least one
router interface before you configure a DVMRP interface.
•
Interface Mode
— Select Enable or Disable from the drop-down menu to set the administrative mode
of the selected DVMRP routing interface.
•
Interface Metric
— Enter the DVMRP metric for the selected interface. This value is sent in DVMRP
messages as the cost to reach this network. Valid values are from 1 to 31.
Configuring a DVMRP Interface
1.
Open the
DVMRP Interface Configuration
page.
2.
Select the interface to configure from the
Interface
field.
3.
Modify the remaining fields as needed.
4.
Click
Apply Changes
.
The interface configuration is saved, and the device is updated.
Configuring a DVMRP Interface Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• DVMRP Commands
The following table summarizes the equivalent CLI commands for this feature.
To Next Page
Loading...
