Dell PowerConnect 8024 User Guide

Configuring IP Multicast 717
• Interface Mode — Displays the administrative mode of the selected DVMRP routing interface, either
Enable or Disable.
•
Protocol State — Displays the operational state of the DVMRP protocol on the selected interface,
either Operational or Non-operational.
•
Local Address — Displays the IP address used as a source address in packets sent from the selected
interface.
•
Interface Metric — Displays the metric used to calculate distance vectors for the selected interface.
Interface Statistics
• Generation ID — Displays the DVMRP generation ID used by the router for the selected interface.
This value is reset every time an interface is (re)started and is placed in prune messages. A change in
generation ID informs the neighbor routers that any previous information about this router should be
discarded.
•
Received Bad Packets — The number of invalid packets received on the selected interface.
•
Received Bad Routes — The number of invalid routes received on the selected interface.
•
Sent Routes — The number of routes sent on the selected interface.
Neighbor Parameters
• Neighbor IP — The IP address of the neighbor whose information is displayed.
•
State — The state of the specified neighbor router on the selected interface, either active or down.
•
Neighbor Uptime — The DVMRP uptime for the specified neighbor on the selected interface. This is
the time since the neighbor entry was learned.
•
Neighbor Expiry Time — The DVMRP expiry time for the specified neighbor on the selected
interface. This is the time left before this neighbor entry ages out, and is not applicable if the neighbor
router's state is down.
•
Generation ID — The DVMRP generation ID for the specified neighbor on the selected interface.
•
Major Version — The DVMRP Major Version for the specified neighbor on the selected interface.
•
Minor Version — The DVMRP Minor Version for the specified neighbor on the selected interface.
•
Capabilities — The DVMRP capabilities of the specified neighbor on the selected interface.
•
Received Routes — The number of routes received for the specified neighbor on the selected
interface.
•
Received Bad Packets — The number of invalid packets received for the specified neighbor on the
selected interface.
•
Received Bad Routes — The number of invalid routes received for the specified neighbor on the
selected interface.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries