Dräger Isolette C2000 - Page 337

High Dual Access Hood Assembly with Left & Right Access Doors (P/N 83 200 73) (Series 00 Model
Only)
Chapter 5: Parts List
Page 5 - 36 Isolette® Infant Incubator (Model C2000) Service Manual
Table 5-8. High Dual Access Hood Assembly with Left & Right Access
Doors (P/N 83 200 73) (Series 00 Model Only)
Item Number Part Number Quantity Description
1 83 200 31 1 Hood, high, dual access, access
doors left and right
2 83 200 15 4 Keeper, access panel latch
3 83 200 10 1 Hinge, hood/access panel, right front
4 83 200 11 1 Hinge, hood/access panel, left front
5 83 200 12 1 Hinge, hood/access panel, left rear
6 83 200 13 1 Hinge, hood/access panel, right rear
7 83 200 20 10 Grommet, access
8 68 232 24 2 Standoff, #6-32 inside diameter, 0.38"
outside diameter, 0.44" long, acety-
lene
9 83 300 05 2 Door, access
10 81 020 20 2 Clamp, cable, spring type, nylon,
0.38" inside diameter
11 83 300 11 1 Access door cuff, disposable,
replacement, carton of 100
12 83 300 07 2 Gasket, access door
13 83 300 08 4 Pivot hinge, access door
14 68 510 10 2 Spring, torsion, 0.27" outside diame-
ter, 0.30" wide, 0.365" long
15 99 024 19 20 Screw, #6-32 x 9/16", truss, phillips,
stainless steel, Nylok®
a
16 83 900 09 2 Replacement kit, access door latch
17 83 300 15 2 Latch mount, access door
18 99 024 18 2 Screw, #6-32 x 9/16", truss, phillips,
stainless steel
19 99 042 92 8 Screw, #10-32 x ¾", truss, phillips,
stainless steel, Nylok®, step bolt
20 99 024 43 4 Screw, #6-32 x 5/8", truss, phillips,
stainless steel
21 83 200 45 2 Slide assembly, sensor module
22 83 200 42 1 Plate, cover, no calibration fixture
23 99 105 02 4 Nut, hex, #6-32, stainless steel