Dräger Isolette C2000 Service Manual

2.6 Hood Does Not Tilt or Close Properly
Chapter 2: Troubleshooting Procedures
Page 2 - 60 Isolette® Infant Incubator (Model C2000) Service Manual
2.6 Hood Does Not Tilt or Close Properly
1. Perform the following:
a. Disconnect the weighing scale cable (A) from the sensor module
assembly (B) (see figure 2-23 on page 2-61).
b. Slowly tilt the hood assembly (C) back until it comes to rest.
The hood assembly (C) rests once it reaches its fully opened
position.
Yes No
↓→Replace the pivot/hook lock assembly bracket (D) or the
pivot bracket (E) (refer to procedure 4.28 on page 4-77). If
this solves the problem, go to “Final Actions” on page 2-24.
Otherwise, go to step 2.
2. Perform the following:
a. On a unit equipped with the pivot/hook lock assembly bracket
(D), pull on and hold the knob (F) located on the right rear
pivot/hood lock assembly bracket (D).
b. Lower the hood assembly (C) to its closed position.
The problem still exists.
Yes No
↓→Connect the weighing scale cable (A) to the sensor module
assembly (B), and go to “Final Actions” on page 2-24.
3. Check the area around the hood assembly (C) for obstruction, such
as blankets between the hood assembly (C) and the shell assembly
(G), or objects above the hood assembly (C). The area around the
hood assembly (C) is free from obstruction.
Yes No
↓→Remove the obstruction. If this solves the problem, go to
“Final Actions” on page 2-24. Otherwise, go to step 4.
4. Replace the hood assembly (C) (refer to procedure 4.5 on page
4-14). This solves the problem.
Yes No
↓→For assistance, call Technical Support at (800) 437-2437.

Dräger Isolette C2000 Specifications

General

Brand	Dräger
Model	Isolette C2000
Category	Medical Equipment
Language	English