Getting Started
Chapter 2: Troubleshooting Procedures
Isolette® Infant Incubator (Model C2000) Service Manual Page 2 - 5
2
Getting Started
WARNING:
Only facility-authorized personnel should troubleshoot the Model C2000
Isolette® Infant Incubator. Troubleshooting by unauthorized personnel
could result in personal injury or equipment damage.
Begin each procedure in this chapter with step 1. Follow the sequence
outlined (each step assumes the previous step has been completed). In
each step, the normal operation of the product can be confirmed by
answering Yes or No to the statement. Your response will lead to
another step in the procedure, a repair analysis procedure (RAP), or a
component replacement. If more than one component is listed, replace
them in the given order.
To begin gathering information about the problem, start with Initial
Actions.
To isolate or identify a problem and to verify the repair after completing
each corrective action (replacing or adjusting a part, seating a
connector, etc.), perform the Function Checks.
To verify the repair, perform the Final Actions after the Function
Checks.
If troubleshooting procedures do not isolate the problem, call Technical
Support at (800) 437-2437 for assistance.
Initial Actions
To gather information from operators concerning problems with the
Isolette® Infant Incubator, use Initial Actions. Note symptoms or other
information concerning the problem that the operator describes. This
information helps identify the probable cause.
1. Someone who can explain the problem is available.
Yes No
↓→Go to “Function Checks” on page 2-6.
2. Ask that person to demonstrate or explain the problem. The problem
can be duplicated.
To Next Page
Loading...
Need help?
General
