Tool and Supply Requirements
Chapter 6: General Procedures
Page 6 - 36 Isolette® Infant Incubator (Model C2000) Service Manual
Tool and Supply Requirements
To service the Isolette® Infant Incubator, the following tools and
supplies are required:
• Phillips head screwdriver
• Small screwdriver
• 7/16" socket wrench
• 7/32" socket wrench
• 1/8" hex head wrench
• 9/64" Allen™
1
wrench
• 5 mm hex key or 3/16" hex key
• Pliers (two pair)
• Long-nose pliers
• Needle-nose pliers
• Nut driver
• Calibrated oxygen analyzer
• Oxygen flowmeter
• Calibrated leakage tester
• 3/16" inner diameter surgical tubing
• 12" long wooden prop
• Flat padded surface
• Distilled water
• Clean cloth
• Ruler
• Pencil
• Small hack saw
• Emery board
• Computer equipped with a CD-ROM drive, an available RS-232
communications port, and Microsoft Windows®
2
95 or later version
operating system
1. Allen™ is a trademark of Industrial Fasteners, Inc.
2. Microsoft Windows® is a registered trademark of Microsoft Corporation.
To Next Page