Cleaning
Chapter 6: General Procedures
Isolette® Infant Incubator (Model C2000) Service Manual Page 6 - 5
6
Controller, Shell, and Pedestal Stand
CAUTION:
Some chemical cleaning agents may be conductive and/or leave a
residue that may enable a build-up of conductive dust or dirt. Do not
permit cleaning agents to contact electrical components. Do not spray
cleaning solutions onto any of these surfaces.
Use an EPA-registered cleanser/disinfectant to clean all surfaces
thoroughly; then dry with a clean cloth or paper towel.
CAUTION:
When cleaning the interior of the incubator shell, prevent liquids from
entering the motor shaft opening. Equipment damage could occur.
In addition, check for fluids that may have dripped onto the bottom
surface of the humidity tray opening. If fluids are present, use a clean
paper towel dampened with a cleanser/disinfectant to wipe the surface
dry.
Hood, Sensor Module, and Heat Shields
CAUTION:
Alcohol can cause crazing of the clear acrylic hood. Do not use alcohol
for cleaning.
CAUTION:
Do not expose the hood assembly to direct radiation from germicidal
lamps. Ultraviolet radiation from these sources can cause cracking of
gaskets, fading of paint, and crazing of the clear acrylic hood.
NOTE:
The heat shields are hinged on the access panels or the rear wall of the
incubator.
Release the heat shield (A) from the access panel (B) or the rear wall
by pressing on the latches (C) located along its top (see figure 6-1 on
page 6-6).
To Next Page
Loading...
Need help?
General
