Dräger Isolette C2000 - Page 44

Chapter 2: Troubleshooting Procedures
Isolette® Infant Incubator (Model C2000) Service Manual Page 2 - 3
2
Incubator Takes Longer Than One Hour to Warm Up to the Air Set
Temperature. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 99
Air Set Temperature Cannot Be Maintained. . . . . . . . . . . . . . . . . . . . . . 2 - 101
Low Air Temperature Alarm or High Air Temperature Alarm Does Not Sound
When Air Temperature Drops or Rises Out of Specification . . . . . . . . . 2 - 102
Low Skin Temperature Alarm or High Skin Temperature Alarm Does Not Sound
When Skin Temperature Drops or Rises Out of Specification . . . . . . . . 2 - 103
When Skin Probes are Disconnected, Connect Skin 1 Probe Alarm
Does Not Sound . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 104
Incubator’s Air Temperature Exceeds Air Set Temperature by 1.5 C or Greater, or
Infant’s Skin Temperature Exceeds Skin Set Temperature by 1.0 C or
Greater . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 105
Humidity System Is Not Working Properly . . . . . . . . . . . . . . . . . . . . . . . 2 - 106
Power Failure Alarm Sounds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 108
Skin 1 Probe Does Not Work Properly . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 109
Oxygen System Is Not Working Properly
(Units Equipped With an Oxygen System Only). . . . . . . . . . . . . . . . . . . 2 - 112
Poor Air Circulation Exists Within the Incubator. . . . . . . . . . . . . . . . . . . 2 - 113
Sensor Module Assembly Fails . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 114
Remove Skin 2 Probe Alarm Sounds . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 115
Scale Is Not Working Properly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 116
Oxygen System’s Cal Fail System Prompt Message Appears. . . . . . . . 2 - 119