Chapter 4
| System Management Commands
File Management
– 144 –
Command Mode
Privileged Exec
Command Usage
◆ If the file type is used for system startup, then this file cannot be deleted.
◆ “Factory_Default_Config.cfg” cannot be deleted.
◆ A colon (:) is required after the specified unit number.
◆ If the public key type is not specified, then both DSA and RSA keys will be
deleted.
Example
This example shows how to delete the test2.cfg configuration file from flash
memory.
Console#delete test2.cfg
Console#
Related Commands
dir (144)
delete public-key (272)
dir This command displays a list of files in flash memory.
Syntax
dir [unit:] {boot-rom | config | opcode}: [filename]}
unit - Unit identifier. (Range: 1-8)
boot-rom
- Boot ROM (or diagnostic) image file.
config - Switch configuration file.
opcode - Run-time operation code image file.
filename - Name of configuration file or code image. If this file exists but
contains errors, information on this file cannot be shown.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
◆ If you enter the command dir without any parameters, the system displays all
files.
To Next Page
Loading...
Need help?
General