Chapter 4 Disassembly/Assembly and Adjustment
4.2 Disassembly/Assembly
4-43
REP5.6 (SCC) HARNESS ASSY AC IN (PL5.1.46)
<Removal>
1) Pull the LEVER FRONT R and LEVER FRONT L toward you and open the COVER ASSY FRONT.
2) Remove the COVER ASSY STACK CL. (REP1.7)
3) Remove the COVER ASSY PWB. (REP9.5)
4) Remove the COVER ASSY TOP CL. (REP1.4)
5) Remove the COVER SIDE LEFT CL. (REP1.1)
6) Remove the COVER ASSY RIGHT CL. (REP1.2)
7) Remove the COVER MIDDLE CL. (REP1.3)
8) Remove the GEAR ASSY. (REP7.1)
9) Remove the CHASSIS ASSY CONTROLLER. (REP9.2)
10) Remove the ROS ASSY. (REP10.1)
11) Remove the FRAME ASSY MAIN. (REP9.8)
12) Remove the BASE CHASSIS ASSY with the LVPS 230 and AZUSA HVPS. (REP9.9)
13) Remove the GUIDE ASSY FRONT. (REP5.2)
14) Remove the HARNESS ASSY AC IN to the arrow direction.
<Replacement>
Perform the removal procedures in the reverse order.
NOTE
When replacing the INLET, face the FG terminal to right.
NOTE
When attaching the switch to the GUIDE CST R (PL5.1.7), install the “ON” side of
the switch to upward.
14)
14)
AZS449CA
FG Terminal
SADDLE WIRE
ON
OFF
To Next Page
Loading...
Need help?
General
