Introduction
2. How to use the Service Manual
Preface-3
Chapter 8 Accessories (Not issued)
Chapter 9 BSD (Block Schematic Diagram) (Not issued)
Chapter 10 Machine Overview
This chapter gives an overview of the functions of the main components of DocuPrint 2050.
2.2 Information on Updating
This manual will be revised and sent to each customer engineer as specified below. Revisions must
be incorporated correctly to keep the manual up-to-date.
Updating Procedure
• When the entire manual is revised, "1st Edition" on the front cover will be renewed to 1st Edition,
2nd Edition, 3rd Edition and so on.
• When this manual is partially revised, revisions will be sequentially indicated as Revision A,
Revision B, Revision C, etc. All revised pages will be marked accordingly with "Revision A",
"Revision B", "Revision C" and so on.
Revision Sidebar
When any paragraph, table or figure has been added or amended, a revision sidebar will be
added to indicate where the revision was made.
If the same page is changed again due to a subsequent revision, revision sidebars associated
with the previous revision(s) will be deleted.
(Example)
To Next Page
Loading...
Need help?
General
