Chapter 6 General
6.1 Specifications
6-7
6.1.7.8 Paper throughput
*1 When the paper counter is becoming 31 or more, the slow down mode starts.
- The paper counter counts all paper.
- When the time not printed passes ten minutes or more, the counter clears.
6.1.7.9 Warm-up Time
When the nominal voltage (100 V, 120 V or 220 V) is applied, the FUSER standby temperature
should be reached within the time stated below.
• From the moment of POWER ON to the start of Standby mode: 15 seconds or less
• When a mode change command is received from IOT during the Power Save mode: 15
seconds or less
6.1.7.10 FPOT (First Print Output Time)
FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the START command is
received.
Paper type Paper
Plain paper mode Thick paper mode
ppm
slow down
ppm
slow down
-- Threshold -- Threshold
Plain paper
A3 (SEF) 11.5 -- -- 11.5 -- --
A4 (LEF) 21.0 -- -- 21.0 -- --
A5 (LEF) 18.0 -- -- 18.0 7.8 31 *1
B4 (SEF) 12.0 -- -- 12.0 -- --
B5 (LEF) 21.0 -- -- 21.0 -- --
Letter (LEF) 19.5 -- -- 19.5 -- --
Legal 14 (SEF) 7.8 -- -- 7.8 -- --
Envelope
Postcard
No.4 horizontal
envelope (SEF)
-- -- -- 7.8 4.1 31 *1
Postcard (SEF) -- -- -- 9.0 4.4 31 *1
Reply card (SEF) -- -- -- 8.3 4.2 31 *1
Transparency A4 (LEF) -- -- -- 21.0 -- --
File type J9 J11
FPOT less than 19.5 sec. less than 19.5 sec.
To Next Page
Loading...
Need help?
General
