Chapter 4 Disassembly/Assembly and Adjustment
4.2 Disassembly/Assembly
4-64
REP8.7 HARNESS ASSY HV BTR (PL8.1.5)/(SCC) HARNESS ASSY HV DT (PL8.1.8)/
(SCC) HARNESS ASSY HV TRANS (PL8.1.10)
<Removal>
1) Pull the LEVER FRONT R (PL8.1.11) and LEVER FRONT L (PL8.1.12) toward you and open the
COVER ASSY FRONT.
2) Remove the ROLL ASSY BTR. (REP8.3)
3) Remove the COVER ASSY STACK CL. (REP1.7)
CAUTION
Be careful not to damage the FFC OPP CL (PL1.1.21) in the procedure
below.
4) Remove the COVER ASSY TOP CL with the FFC OPP CL. (REP1.4)
5) Remove the COVER SIDE LEFT CL. (REP1.1)
6) Remove the COVER ASSY RIGHT CL. (REP1.2)
7) Remove the COVER FRONT LEFT. (REP3.7)
8) Remove the COVER FRONT RIGHT. (REP3.6)
9) Remove the FRAME BASE RTD TRAY HN. (Refer to REP 3.5)
10) Remove the TRAY ASSY FRONT CL. (REP3.8)
11) Remove the FRONT UNIT. (REP3.1)
12) Remove the FRAME ASSY FRONT. (REP8.6)
13) Remove the terminal of the HARNESS ASSY HV TRANS from the CHUTE TRANS (PL8.1.9).
14) Release the three hooks with the straight-head screwdriver and remove the CHUTE TRANS.
15) Remove a screw (gold, with flange, tap, 8mm) securing the terminal of the HARNESS ASSY HV
DT.
16) Release the two hooks of the FRAME FRONT (PL8.1.2) with the pliers, remove the left side of the
BEARING BTR (PL8.1.7) and the SPRING BTR (PL8.1.6).
17) Remove the HARNESS ASSY HV BTR, HARNESS ASSY HV DT and HARNESS ASSY HV
TRANS from the hook of the FRAME FRONT (PL8.1.2).
To Next Page
Loading...
Need help?
General
