Chapter 2 Troubleshooting
2.4 How to use PC Diag.
2-40
2.4.1.5 Activation Screen
When the Diagnostic And Software program is activated, the screen below appears. Wait until
the device power is turned on.
CAUTION
If the screen does not change at power-on, the loose connection,
contact error or installed by the privilege of Non-Administrators (in case
of Windows2000 or XP) is thought.
After power-on, the screen appears.
Confirm the version of the software, press the [Page Down] key or [Enter] key to go to the next
page.
Version
To Next Page
Loading...
