Chapter 6 General
6.1 Specifications
6-6
6.1.7 Functions
6.1.7.1 Recording System
Electro-photographic system
6.1.7.2 Exposure System
Semiconductor 1 beam laser
6.1.7.3 Development System
Development with dry type developer
6.1.7.4 Fixing System
Heat fusing of the pressure roll nip system
6.1.7.5 Resolution
600dpi (23.62dots/mm)
6.1.7.6 Operation Mode
The printer can be operated in either of 2 operation modes. The modes are switched over by
command from the printer controller or change of printer operation, etc.
Running mode
State in running or recording operation
Fixing system : Held at operating temperature
Exposure system : Operating status
Recording system : Operating status
Main fan : Operating at high speed
Sub fan : Operating at high speed
Power Save mode
In the case where the printer has not received any data to be printed out within the specified
period of time (default: Three minutes), the printer changes its mode to the Power Save
mode.
Fixing system : Stop status
Exposure system : Stop status
Recording system : Stop status
Main fan : Stop status
Sub fan : Stop status
6.1.7.7 Process Speed
90.0292mm/sec
To Next Page
Loading...
