Chapter 4 Disassembly/Assembly and Adjustment
4.2 Disassembly/Assembly
4-77
REP10. Xerographics
REP10.1 (SCC) ROS ASSY (PL10.1.1)
<Removal>
1) Pull the LEVER FRONT R and LEVER FRONT L toward you and open the COVER ASSY FRONT.
2) Remove the COVER ASSY STACK CL. (REP1.7)
3) Remove the COVER ASSY PWB. (REP9.5)
4) Remove the COVER ASSY TOP CL. (REP1.4)
5) Remove the COVER SIDE LEFT CL. (REP1.1)
6) Remove the COVER ASSY RIGHT CL. (REP1.2)
7) Remove the COVER MIDDLE CL. (REP1.3)
8) Remove the CHASSIS ASSY CONTROLLER. (REP9.2)
9) Remove all cables from the ROS ASSY hooks.
10) Remove the four screws (2 pcs-front: gold, with flange, tap, 10mm/2 pcs-rear: gold, with washer,
8mm) securing the ROS ASSY.
11) Lift the ROS ASSY and remove the front boss. Press the back of the ROS ASSY against the
CHASSIS BASE and lift the front of the ROS ASSY to remove the ASSY upward.
To Next Page
Loading...
Need help?
General
