Chapter 6 General
6.5 Installation Procedure
6-16
6.5 Installation Procedure
6.5.1 Confirming the components packed together with this printer
1. Check that all items listed below are in the box.
1) Main unit
2) Drum/toner cartridge (2K)
3) Power cable
4) CD-ROM
2. Remove the printer from the box and carry it to the installation location. Ensure that the
installation location is equipped with the following conditions.
• Do not expose the printer to direct sunlight.
• Do not expose the printer to direct draft of air-conditioner or heater.
• Temperature range 10 - 32°C, humidity range 15 - 85% (no condensation). Humidity should
be 70% or below at 32°C, and temperature should be 28°C or below at 85% humidity.
NOTE
Sudden temperature fluctuations can affect print quality. Rapid heating of a cold
room or moving the printer from a location with low humidity/temperature to high
humidity/temperature can cause condensation inside the printer, directly interfering
with image transfer. When condensation occurs, leave the printer alone for at least
1 hour to acclimate to the environment before using it.
To Next Page
Loading...
